Daytime Running Lights Controller

详情

Daytime running lights controller manual 
Main features: 
An automatic switch lights: Microcomputer automatic lights when the engine is started, the lights turn off the engine for ****0 seconds delay, 
Experience to illuminate your home with stickers 
(2) open automatically dimming headlights: After opening the headlights, daytime running lights brightness down *0%, to avoid the long-term in full 
Set to work to extend LED life 
3 synchronous flashing lights and turn strengthen a warning, so driving safer 
4 strobe function: When the driver opened the security warning lights, daytime running lights into strobe state 
5 built-in EMC circuit, to avoid interference with on-board computer system 
6 applies voltage of *2V car, Waterproof IP*7 standards 

Operating Mode 
Brightness time line engine work long bright lights, engine stop delay *0 seconds off the lights, turn on the headlights when: Mode 1 
Down *0%, while turning lights stopped working the other modes, the corresponding side of the turn signal flashing lights follow 
Mode **5: 4 kind Baoshan mode 
Key Functions 
Wireless Remote version: A key off key four kinds strobe mode switch B C D key to enter boot mode 1 
Wired controller version: Each time you press the to switch mode, press the shutdown, and then boot into the mode 1 
Line installation 
1 single line six, red positive, black wire connected to the battery positive and negative negative; White lines connected to the headlight dimmer positive; 
Blue, brown line about turning around the turn signal control lines connected to the cathode; Yellow wire to ACC. 
With specific reference to the control box on the back of the wiring diagram. 
2 traces should avoid the heat of the place, take a good long after finishing the wiring harness and secured in the car.