New products photoluminescent pigment and glow in the dark powder for spinning

详情

Color Glow powder/phosphorescent powder for drawing paint:
1. How to choose drawing paint: General Please choose transparent paint or whte paint Color Glow powder/fluorescent powder. Transparent drawing paint or white drawing paint has good light transmittance, no UV resistance; the organic solvent series of drawing paint has good light resistance and good weather resistance and stable chemical properties and good adhesion. So recommend alcohols, propionic acids and epoxy resins. The viscosity of the ink is about ********0 mooring.
 
2. How to choose Color Glow powder/fluorescent powder: please choose finer Color Glow powder/fluorescent powder. The finer Color Glow powder/fluorescent powder is not easy to precipitate And make the surface of the product smooth. If there is precipitation in the process of using, a simple way of mixing can be used to make the glow powder mix evenly.
 
3. How to operate: The proportion of the glow powder can be adjusted by the weight of 1:1.
1). The firstly You should add a Color Glow powder/fluorescent powder and then slowly adding drawing paint or solvent, when drawing paint or solvent covered Color Glow powder/fluorescent powder, please stop.
2). after about half an hour to 1 hours (how much time waiting is, according to the situation) When Color Glow powder/fluorescent powder can be fully wet by drawing paint or solvent, then add the remaining drawing paint or solvent, then mixing. This process will avoid producing bubbles. 3). Before brushing the glowing drawing paint, to add a white substrate on the surface objects or directly brush the glowing drawing paint on white material, which can improve the brightness and extend light time. If the bottom color is dark, the brightness will be reduced. Thickness of glowing layer should not be lower than **0um. So should choose *****0 mesh silk-screen.4). Glowing drawing paint After drying, brushing a layer of varnish with good water resistance for improving water resistance and surface smooth of products.
 
4. Glow drawing paint can continue to shine for more than a few hours in the dark after absorbing any visible light. With high heat resistance, wear resistance, suitable for all kinds of surface paper, textile, wood, plastic, metal, pottery and other materials.
冷喷涂工艺的操作： 首先，将夜光粉与油墨混合，混合比例约为****0％，混合时避免与铁接触，混合均匀后，采用喷涂工艺，喷涂到玻璃表面，一般*- 3次，比封口白色。由于发光粉的比例比较大，所以在搅拌印台油墨的同时进行喷涂会更加均匀。它应始终包含发光粉，否则一旦发生发光粉沉降，会导致墨水内部的喷雾中不包含发光粉或发光粉较少，从而会产生强度差或不发光的现象。
至于热熔的过程比较复杂： 一般是丝网印刷工艺。首先，将夜光粉与印台油墨均匀混合，比例约为****0％，在混合过程中不能与铁接触。混合后使用丝网是在玻璃背面*0目印刷**3次。至少在印刷发光层后密封一层白色，然后烧结，以避免高温影响温度不超过**0度的发光强度。