Motion Controller ZXC100-400

详情

Feature 1) Be able to control different kinds of step motor separately; 4 axis control maximumly 2) Multi-Axis Linear Interpolation; 3 Axis simultaneous motion 3) Curvilinear and Trapezoidal motion is possible 4) 3 kinds of measurement units 1) Impulse 2) Angle 3) Millimeter 5) All 4 Axis with closed loop control 6) 2 Axis Circular interpolation 7) Consecutive interpolation motion between multi-segment lines and arcs 8) Be able to set any position as initial point 9) Close loop position control via grating, position accuracy depends on that of grating encoder *0) Be able to set initial speed, constant speed, acceleration, limit position for each axis separately *1) Automatical clearance compensation to improve motion precision *2) Multiple modes of zero position reset to meet different requirement *3) Be able to decode 4 encoder signal and record position deviation *4) Step and incremental motion control mode *5) LCD Display *6) Electronic handweel impulse input is possible *7) Flexible RS**2 communication protocol, be able to save and run more than **0 user instructions Technical Parameter 1) Power supply **0V/*0Hz 2) Maximum 4 Axis control 3) Applicable Step Motor and driving power: Two phase step motor, 3.5A 4) Microstepping: 2, 4, 8, *6, *2, *4, **8 5) Maximum Impulse Speed: **0Kpps 6) RS**2 port 7) Accelerating/Decelerating mode: Triangle or Trapezoid 8) Grating coding port: TTL 9) Temperateur range: **0� ~ *0� *0) Action power: 5V±5%