看起來你不是TradeKey.com的會員。 立即註冊,與全球超過7百萬的進口商和出口商建立聯繫。 点击注册--免费! |
BOOK A CALL
Book Call On Your Favorite Time
Code
🗘

By Signing Up. I agree to TradeKey.com Terms of Use, Privacy Policy, IPR and receive emails related to our services

Contact Us
Base Lacquer Putty

Base Lacquer Putty

离岸价格

获取最新报价

|

Minimum Order

位置:

-

最小订单价格:

-

最小订单:

2tons

包装细节:

-

交货时间:

-

供应能力:

1000tons

付款方式:

-

现在联系
免费会员

联系人 Mr. Joe

Longkouxi, Guangzhou, Guangdong

现在联系

详情

Features:
This product is a new high-strength coating bottom ash, mainly used for the leveling rough surface of cement mortar or concrete walls, providing a good base surface for the layer lacquer putty, to reducing the amount of surface lacquer putty and low down the project cost
1, strong cohesive force, can be well attached to the base surface
2, has a certain flexibility, can be a good buffer layer for different substrates of stretching stress
3, excellent aging resistance and good ability of anti-infiltration
4, environmental-friendly product, non-toxic, and safety
Surface Treatment:
The substrate surface should be firm, dry and clean, no grease, no wax, and other loose materials. New plaster surface should maintenance about twelve days before inserting the lacquer putty, do not use cement paste for calendaring. If the wall is too dry, wet the wall before operation till there is no obvious water on the surface
Operation Process:
1, using appropriate amount of water (about 3: 1) to transfer it into a paste (namely *5kg powder + 7.5kg water)
2, according to the water-cement ratio, pouring the water into the stirring barrel, adding the powder, using an electric mixer to make particle paste, put it aside for a few minutes and then a little stirring to gain the better effect
3, using point-mending method to repair the base side for those large different places, after dry use a spatula evenly to spread the slurry on the base surface, and control the thickness under 2mm.
4, dry after *4h, can make the operation of the surface lacquer putty.
Technical Reference:
Compression and shear bond strength≥1.2MPa
original tensile strength≥0.6MPa
Waterproof tensile strength≥0.5MPa
Tensile strength resistance to freezing and thawing≥0.5MPa
Tensile strength of alkali ≥0.5MPa
Heat-tensile bond strength≥0.5MPa
Normal Amount:
about 1.5~2.0kg/m2, according to the smooth of the surface
Cautions:
1, never mix the dry slurry with water and use again
2, this product requiring operating under 5℃~*0℃ situation, never operate under raining.
Store Method:
Store in cool and dry place, unopened product can be saved for one year.
Packing:
2kg/bag, *5kg/bag
 

Send a direct inquiry to this supplier

至:

Mr. Joe < Guangzhou Mebong Architectural Decoration Co., Ltd. >

我想知道: