Z-Wave dual paddle wall Switch TZ66D

详情

New desgined Z-Wave wall mounted switch mainly for Intelligent Residential Quarters and Home Automation!

Features:

The TKB Z-Wave dual wall switch is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol

It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.

Beside the local switch the unit can control other Z-Wave units remotely in up to three additional Z-Wave groups, which are associated with this device. Tipping one time or two times the switching paddle performs the control. The left paddle controls the local load while the right paddle remotely controls Z-Wave associated devices only. The association of further Z-Wave devices needs to be done by a Z-Wave controller.The unit is powered by **0V power and needs a pattress box with **0 V power wires for installation. The unit is shipped completely with electronics, switching paddle and mounting frame in white style. It is designed for use within a *-wire system, which means that a neutral wire is needed for operations.

Introduction

This Wall Mounted Switch is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other types can be added to the system and will also act as repeaters if they support this function of repeating the signal received to other modules in the system.

As part of a Z-Wave network, the TZ**-D will also act as a wireless repeater to insure that commands intended for another device in the network are received. This is useful when the device would otherwise be out of the radio range of the wireless controller.

Technical Data

Power: **0 VAC, *0 Hz

Signal (Frequency): **8.*2 MHz

Maximum Load – Resistive: 6 Amps (***0 watts) maximum, **0 VAC

Range: Up to *0 meters line of sight between the Wireless Controller and /or the closest Z-Wave Receiver Module 

Delivery:

Any questions about products info and delivery, please contact us by email. Thanks