详情
KRONE MODULE Reed
Disconnection
It is made up with
the plastic shell and reed terminals for the cable continued
connecting into the side of a module. The over-current and
over-voltage protection to switches and other communications
equipment can be realized if it worked with the security unit.
1,The clamp module compatible with the
KRONE LSA-PLUS SERIES module.
2,The point of contact design is based on the principle of
airtight, it formed a reliable connection between the reed and the
cable.
3,Size: (H x W x D): **2.5mm x *1.5mm x *0.5mm (*0 pairs)
4,Environmental conditions: temperature 5 ~ *0 ℃; Relative humidity
<*5% (**0 ° C); Atmospheric pressure *0 ~ **6KPa<br /> 5,
Pulling-out force: tin bronze, silver plating (*0 ~
*0uinch)，appropriate diameter 0.4 ~ 0.6mm,
pulling-out force not less than *5N.
6, Flame retardance: plastic parts are made of PBT or flame
retardant ABS, Combustibility should be achieved GB / T ***9.*****5
standard.
7, Insulation resistance: under the standard atmospheric pressure,
between any one of two terminals unconnected, the insulation
resistance is not less than ***0MΩ.
8,Intermediate resistance between reed terminators:no more than
7mΩ（under standard atmospheric
pressure, between any one of two terminals
unconnected）.
9, Intermediate resistance: no more than 7mΩ under standard
examination condition.
*0 Life: durability
**0 cycles.
*1, Types and specifications: *0 pairs, disconnection module.
For cable splicing into the side of a module. The over-current and
over-voltage protection to switches and other communications
equipment can be realized if it worked with the security unit.
Environmental requirements:
1) Operating Temperature:
*5 ℃ ~ *0 ℃
2) Storage temperature:
**5 ℃ ~ *5 ℃
3) Relative humidity: ≤
*5% (**0 ° C)
4) Storage relative
humidity: ≤ *5%
5) Atmospheric pressure:
*0KPa ~ **6Kpa
*2, Module indicators:
1) Lead material: single strand
of plastic insulated wire;
2) The wire diameter:
0.**0.6mm;
3) The maximum outside diameter
(including insulation included): ≤ 1.4mm
4) a single wire along the
notch perpendicular to the direction of the pull-off strength: ≥
*5N;
5) protector spring and wiring
of the contact pressure between the terminal piece: f>
*0g
