详情
ford scanner,ford diagnosis,ford tester,VCM IDS,FORD VCM
IDS,IDS VCM,VCM IDS FORD,VCM KIT
The Vehicle Communication Module (VCM) is a high
performance, buggerized, vehicle serial communications gateway.
This device provides multiple vehicle serial communication
interfaces to meet the requirements of all Ford Motor Company
vehicles.
The Ford Integrated Diagnostic System (IDS) will be the
only equipment that provides complete diagnostic coverage of
current and future Ford, Lincoln and Mercury vehicles in North
America.
The IDS package replaces the Worldwide Diagnostic System
(WDS). The IDS application will perform the identical functions of
the WDS and allows dealership technicians to diagnose and service
Ford, Lincoln, Mazda, Mercury, Land Rover & Jaguar
vehicles.
Diagnostic Functionality
** For in code calculate by using this tool, please
refer to INCODE => OUTCODE
Self Test
Retrieve CMDTC's
KOEO
(Key-On-Engine-Off)
KOER
(Key-On-Engine-Running)
Data Logger
Body
Chassis
Electrical
Power train
Pressure/Vacuum
Tests
Network Test
Body Tools
PATS Functions
Remote Keyless
Entry
Factory Keyless Entry
Code
Restraints
Chassis Tools
ABS Service Bleed
IVD Initialization
Sequence
Ride Height
Calibration
Pneumatic Test
Accurate Trim
Test
Electrical Tools
Charging System
Test
Parking Aid Switch
Test
Audio
Powertrain Tools
EVAP Test
Fuel Economy Test
Fuel System Test/Relative Injector
Flow Test
(IDS - Some vehicles require only
VCM)
Ignition System
Test
Spark Duration
PIDs
Power Balance
Test
Relative Compression
Test
Transmission Test
(IDS - Some vehicles require only
VCM)
Engine Checks and OBD
Tests
(Drive Cycle, Mode *1, Mode *6 &
Mode *9)
EGR Test
Other Powertrain tests &
functions
Digital Multimeter
Basic DMM
functions
(Volts, resistance,
frequency)
Current measurements (*0 Amps/**0
Amps)
Pressure/Vacuum measurements with
PVT
Oscilloscope Tools
Oscilloscope
Alternator ripple
COP (Coil-On-Plug) stress
test
Signal Generator Monitor (SGM)
Vehicle Data Recorder (VDR)
Application Overview
Integrated Diagnostic Software (IDS) is the next
generation diagnostic tool. IDS integrates WDS software modified to
run on an off-the-shelf laptop with the Vehicle Communication
Module (VCM) currently used in NGS+ and PDS, and a new Vehicle
Measurement Module (VMM).
Vehicle Diagnostic Connectors
The VCM **-pin DLC cable is used to connect the VCM to
the vehicle. The VCM and VMM connect to the laptop through the
Ethernet-USB Adapter Cable (H**6/H**6).
Interface Devices
The interface devices that are used with this
application are:
1.VCM Vehicle Communication Module: This device provides
all link based functionality including: Data logger, Self test,
Service Functions, Module Configuration , etc.
2.VMM Vehicle Measurement Module :This device provides
the following functionality: Oscilloscope, Digital Multi-Meter,
Ignition System Test, Fuel System Test, and SGM.
Note that the application will detect the interface
device that is connected to the laptop. Indicator icons will appear
at the bottom right-hand corner of the IDS screen when the VCM
and/or VMM are connected.
Supported languages:
English, German, French, Italian, Spanish, Netherlands,
Swedish, Danish, Norwegian, Portuguese, Slovak
Ford VCM IDS Package includes:
1 Vehicle communication module - VCM
2 **-pin DLC long cable
3 IDS 4m PC Ethernet-USB host cable
4 DVD V*0 (Ford/Mazda)
5 DVD V**3 (Land Rover/Jaguar)
