1.*5mm standard DIN rail installation, comply with DIN EN ****2.Or front boards setting (mounting holes center distance *3mm).Either is ok.
2.Pole 6 width (modulus *2.5mm) comply with standard JB/T********3
3.Three tariffs may select *2 daily period of times. The date arbitrary reads the meter every month automatic. Single tariff function in weekend if you wish(Mention it when ordering).
4.There are a clock and maintenance -free backup lithium batteries in it. Battery capacity detection and display all the time. It can keep electricity date for *2 months.The date can be kept forever after blackout.
5.May select cycle display (default) or push the button itemized display, it can display date at most. Can select the date when displayed. The decimal displayed can choose one or two.
6.A port of pulse output passive (polarity), comply with standard IEC *******1.
7.Read and set the meter by far infrared or RS**5 communication date. It is protected by password when setting and operating the meter, comply with standard DL/T*******7.
8.Seven LED instructions respectively power supply state,single of energy impulse,direction of the current, the state rates at that time and the date communication state.
9.Measure the single phase two wire active energy consumption in single direction.It is nothing with the current direction:comply with standard IEC*******1.
*0.Standard configuration type S wiring (Inlet from bottom, outlet from top) for direct connect operation
Standard configuration short terminals cover, may select extension terminals cover for electrical safe.
