The KNX IP Interface is
designed for an intelligent building control system, which is used
for facilitating communication between the Ethernet network and the
KNX system. The KNX IP Interface connects
the EIB/KNX system with the Ethernet network via an Ethernet
RJ*5interfacein the
front，It serves as an interface
between KNX installations and IP networks and can configure,
parameterize and commission the EIB/KNX installation as well
as bus monitor via the LAN
using the ETS(ETS3 or
later)software. For operation an additional
*0V DC supply is necessary.The bus connection and auxiliary power supply
connection are carried out via using EIB bus connection
terminals. The device adopts an Ethernet
RJ*5interfaceto connect with LAN network. The network interface
can be operated with a transmission speed of *0/**0Mbit/s Auto
Sensing. The IP address of the device
can be fixed or can be received from a DHCP server. If you need to
remain the IP address static or here no DHCP server on the network,
you can assign a fixed IP address to the device via ETS. The
application program is preloaded in the factory, the IP
address is fixed, and the port number is set to ***1.
(Note: the device cannot program itself, but need via
other communication interface device to program
it.) The KNX IP Interface is able
to use the Engineering Tool Software ETS (ETS3 or later) with a VD4
file to allocate the physical address and set the parameter. The
factory default physical addresses are *5.*5.**5, and the address
can be modified directly via local interface settings of
ETS. The KNX IP Interface is a
modular installation device. It can be installed in the
distribution board on *5mm mounting rails according to EN *0
**5. This manual provides the
technical information about the KNX IP Interface as well as
assembly and programming in detail for users, and explains how to
use the interface device by the application examples
