sand dredger

Our company can design and fabricate 6 inch to *0 inch cutter suction dredger according to clients requirement. at present, we have 5 set cutter suction dredger in our factory and 3 set cutter suction dredger have been finished. the capacity of the dredger range from **0m3/hr to ***0m3/hr,dredging depth range from 1m to *5m, discharge distance is about ***0m.which can satisfy different demands.

1. The Cutter Suction Dredger of steel construction,  non self-propelled, dismountable type, is able to berth and dredge at any waters both in the coastal area and inland rivers.In the course of technical designing, we have considered special requirements for local tropical climate conditions such as meteorological and waters distributing state etc.

2. Its hull consists of a main pontoon and two side pontoons, which is to be easy to dismantle or mount for transportation by road, rail or water, and is to be easy to reassemble at project site.The engines and dredge pump are located in the center pontoon,the 2 side pontoons serve as fuel bunkers,ballast tanks and storage tanks.

3. The dredger is powered by diesel engines. The main diesel engine is to drive the dredge pump, and in the free part of the engine, one set of power distributor is equipped, to supply power for all other equipments such as cutter, swing and ladder winches, and the spud rams etc.

4. The spacious control cabin is ergonomically designed  with **0 degree view. All the operation buttons, swifts, indicators, gauges are equipped on the control desk. Only two operators can control all the dredger in the operation room.

5. The dredger is painted by 4 layers of marine paint to protect from the corrosion. The ZINC anode can be used to give better anti-corrosion function.