650mm simple hydraulic slitting line

Composed of hydraulic decoiler, slitter, tension station and recoiler only

 

1) Specification of material:

(1) Raw material: Carbon steel coils

(2) Thickness: 0.3 ~ 3.0 mm (Max.)

(3) Width: **0 mm.

(4) Inside diameter of mother coil: **8 mm

(5) Outside diameter of mother coil: Max. 1,**0 mm.

(6) Coil weight: Max. *0 MT

 

2) Size of finished coil:

(1) Inside diameter: **8 mm

(2) Outside diameter: Max. 1,**0.

(3) Coil weight: Max. *0 MT.

(4) Min slit width: *0 mm.

 

3) Line speed: 0~**0m/min 

 

 

The proposed slitting line will function as longitude cutter to slit jumbo coils into baby coils for final usage. In the beginning, jumbo coil is loaded on the coil car by overhead crane and brought to the decoiler by operating the coil car. Coil car centralizes the coil under decoiler’s mandrel and the coil is mounted on the decoiler. Mandrel is expanded. Snubber roll rotates the coil. Peeler breaks the straps and brings the pre end upto Pinch roll. The Pinch roll drives the coil end upto the slitter. Then its drive is disconnected. Slitter moves the slitted strips further. Slitted strips are threaded through loop table and drag tension station into the recoiler’s drum. Recoiler winds one turn on loose coil.Then drag tensioner and loop are put into operation. Slitter and recoiler run simultaneously in synchronization. As the coil build up, the recoiler rpm correspondingly goes down to keep desired constant line speed. This process goes on until the end of coil on decoiler. The slitted coil is pushed on the exit coil car trolley through a pusher plate operated by hydraulic cylinder. The side slitted scrap is wound on the scrap winder units provided on both sides of the slitter.