详情
Introduction of *0,******0,**0m3/ year AAC plant
1. Annual production capacity of production line: *0,
**0m3/year**0, **0 m3/year, **0, **0 m3/year,
**0, **0 m3/year, **0, **0m3 /year,
2. Drying methods: using autoclave
3. Raw material: Fly ash(or Sand), cement, lime, gypsum,
aluminum powder paste, etc.
The autoclaved aerated concrete block can be produced with
different technologies according to differences in quality and
category.
4. Product specification(general specification)
Length: **0mm
Height: **0mm; **0mm; **0mm
Width: *0mm; **0mm; **0mm; **0mm(increased gradually by
*0)
*0mm; *5mm; **0mm; **5mm; **0mm
(increased gradually by *5)
5. Quality standard: in conformity with GB/T*********7
Standard
6. Production technology:
According to raw material's category, quality and
technological characteristics of main equipments, etc, different
technologies can be adopted to produce aerated concrete block.
Generally, fly ash or silica sand is grinded into slurry with
water, and then mixed with lime powder, proper cement, gypsum and
aluminum powder paste and finally filled into mould. After
maintaining, foaming and solidifying, blocks or plank of
different specifications will be cut out and conveyed by trolley
into autoclave. Under the high temperature and saturated steaming
curing, celluar and light-weight aerated concrete products will
be formed. The steps are as follows:
(1) The raw materials such as lime, cement, gypsum, sand(or
fly ash), etc are stored in silo(tank) for use after
treatment.
(2) Aluminum powder or aluminum paste is stored for use
after treatment.
(3) Raw material is measured by electrical scale with
certain proportion. After measured, aluminum powder and water are
fed into aluminum powder mixer to make into suspension
liquid.
(4) Water for proportioning( cold water or hot water from
hot water tank) is measured by electrical scale
(5) After measured, raw materials and aluminum liquid are
fed into casting mixer orderly to be mixed evenly and cast in
moulds(if making plank, then reinforcing mesh should be put in
the mould before hand)
(6) After stopping and precuring under certain temperature
for certain time, the green blocks will reach to certain
strength. And then they are turned *0° by turning hanger and onto
cutter for demoulding and cutting.
a. doing side cutting and milling groove first
b. doing vertical level cutting secondly
c. doing horizontal cutting finally
d. cut green blocks should be handled by travelling crane
to steaming cart before autoclave for palletizing and
grouping.
(7) Grouped green blocks are entered into autoclave for
steam curing.
(8) After leaving autoclave, cured products are severed by
block severing machine.
(9) Then finished products are conveyed to finished product
storage yard and stacked according to specification...
(*0) After product discharge, the steam carts and side
plates will be back for next circulation. After cleaned, they are
grouped with mould frame demoulded from turning hanger and turned
*0° and then they are returned to casting mixer for next
casting.
| 国家: |
China |
| 型号: |
different models
|
| 离岸价格: |
（面議）
获取最新报价
|
| 位置: |
China |
| 最小订单价格: |
- |
| 最小订单: |
1 Unit |
| 包装细节: |
Export standard |
| 交货时间: |
according to the model of machinery |
| 供应能力: |
1 Unit per Week |
| 付款方式: |
L/C, T/T |
| 產品組 : |
- |
