Type
AS
is a roller type freewheel non-bearing supported. Bearings are
required to support axial and radial loads. Lubrication and
sealing must also be provided by the installation. Nominal
outside dimensions are the same as series *2...Ball
bearings.
A typical arrangement is to install this type alongside a series
*2 bearing within the same location tolerances, as shown on the
following page. The inner race is keyed to the shaft (except 6 mm
bore).
The outer race has a positive r6 tolerance to give a press fit in
a H7 housing. The outer housing must be strong enough
To not expand after assembly. This design can accept an axial
misalignment of inner and outer race of ± S/2
