Besturn Engine Disassembly and Assembly Operation Training Platform

详情

Based on a real Besturn engine which can operate in all modes such as start, acceleration and deceleration, it visually demonstrates the operating conditions and parameters of each system of the engine. Instruments and meters can test the resistance, voltage, frequency, pulse width, duty ratio, waveform and conductivity. The car diagnostic tool can display the variation of parameters such as engine speed, injection pressure and intake manifold pressure in real time. The assembly rotation can be partly tested, analyzed and repaired.

Teaching items:

1. Knowledge of the mechanical composition of engine;

2. Mastery of electronic control system of electronic control engine;

3. Mastery of installation position, principle and signal measurement of electronic components of air supply system;

4. Mastery of installation position, principle and signal measurement of electronic components of fuel supply system;

5. Mastery of installation position, principle and signal measurement of electronic components of ignition supply system;

6. Mastery of installation position, principle and signal measurement of electronic components of idling supply system;

7. Mastery of installation position, principle and signal measurement of electronic components of air intake and exhaust system;

8. Mastery of comprehensive fault analysis and data analysis on engine;

9. Schematic circuit diagram of electronic control engine system;

Practicing items:

1. Measurement of master control transducer of engine;

2. Measurement of auxiliary transducer of engine;

3. Measurement of feedback transducer of engine;

4. Measurement of executive components of engine;

5. Measurement of fuel system pressure;

6. Measurement of vacuum degree of engine;

7. Measurement of ignition timing and misfire rate of engine;

8. Data analysis of engine.