Common Problems

详情

1. Deviation And Left-right Offset Of The BoardReason: Uneven Gap Between Upper And Lower Pressure Rollers, Deviation Of Feeding Guide, And Uneven Machine Body.Solution: Adjust The Gap Between The Rollers On Both Sides, Calibrate The Feeding Edge, Level The Machine Base, And Ensure That The Board Is Fed In A Straight Line.2. Scratches And Paint Peeling On The Board SurfaceReason: The Pressure Roller Has Burrs, Sticky Iron Chips, Rust Stains, And The Material Guide Components Are Not Smooth.Solution: Polish Roller Burrs, Clean Surface Debris, Regularly Wipe And Maintain, And Perform Rust Prevention Treatment On Rusted Areas.3. Irregular Tile Shape, Raised Edges, And DeformationReason: Wear Of Rollers, Excessive Or Insufficient Pressure, Inconsistent Thickness Of Sheet Metal.Solution: Fine Tune The Forming Roller Pressure, Replace Worn Rollers, Use Color Steel Plates That Meet Specifications, And Feed At A Constant Speed.4. Stuck Feeding And Poor FeedingReason: Chain Too Tight/loose, Roller Stuck With Debris, Lack Of Oil In Transmission Components.Solution: Adjust The Tension Of The Chain, Clean Up Equipment Debris, Regularly Add Lubricating Oil, And Reduce Operating Resistance.5. Cutting Sizes Of Varying LengthsReason: Loose Fixed Length Limit Switch, Encoder Deviation, Slow Cutting Hydraulic Response.Solution: Tighten The Limit Device, Recalibrate The Sizing Parameters, Check The Hydraulic Oil, And Maintain The Cut-off Cylinder.6. The Machine Has Loud Noise And Abnormal NoisesReason: Oil Shortage In Bearings, Loose Screws, And Worn Gears.Solution: Tighten The Screws Of The Entire Machine, Regularly Add Lubricating Grease, And Inspect And Replace Damaged Bearings.7. Folding And Creasing Of The Board SurfaceReason: The Feeding Speed Is Too Fast And The Roller Arrangement Is Misaligned.Solution: Reduce Operating Speed, Recalibrate The Parallelism Of Each Component Roller, And Ensure Smooth And Uniform Production.