DC 12V/24V 3 in 1 power station mini jump starter for car,Iphone5,laptop

详情

DC *2V/*4V 3 in 1 power station mini jump starter for car,Iphone5,laptop

Top *0 features for *2V/*4V Emergency car jump starter for laptop/phone/ipad/Mp3/Mp4

1. Car jump start *0 times. Peak current can reach **0A.

2. Reverse charge protection

3. Extreme cold weather (**0°C) Jump starter

4. Full change Iphone 7 times

5. Laptop power supply 2h

6. *2V car electronic products (i.e. car refrigerator) power supply

7. Illumination *4h

8.Warming flashing, SOS signal *0h

9. Weight and size is only 1/*0 of traditional lead-acid jump starter

*0. More than 3 years lifetime
 

Specification of *2V/*4V Emergency car jump starter for laptop/phone/ipad/Mp3/Mp4

Advantages of *2V/*4V Emergency car jump starter for laptop/phone/ipad/Mp3/Mp4

1.  The smallest and lightest portable multi-function jump starter with patented

 technology in the current market.

2.  Use ****0mAh high capacity and high power battery. Support fast charging, low self- discharge,cycles can reach ***0times.

3. Support *2V vehicle start, and charge for various mobile phone. PSP, MP3/MP4,

PDA,notebook, car refrigerator and so on.

4.  Flashlight function. Support 3 kind lighting modes (light, strobe, SOS )

5.  Multiple safety protection design ensure jump starter zero defect.
 

Instructions for use:

1.Select the appropriate voltage and connector for the electronic device to charge/power supply .

2.Press the switch to start charging when your device connected with Epower, if you unplug

 the cable, auto-sleep will start in one minute .

3.Five lights will flash circularly during the charging by Epower and all lights will keep bright

 when your device is full-charged.
 

4.During the charging for your device, LED lights indicate the balance power of built-in

battery of Epower,Four lights indicate *0% balance, three lights indicate *0% balance,

 two lights indicate *0% balance and one light indicates *0% balance. The built-in battery

 is empty when all LED lights start to flash.

5.Press the switch five seconds to start if you want to use LED for illumination and select

 the status (light, strobe, SOS and close) by pressing the switch to transform.

6.Store the product in a cool and dry place and away direct sunlight
 

Special note:

1.To start *2V cars, please make sure at least THREE LED lights of EPOWER are bright .

2.Connect the red battery clip to the battery positive (+) and black clip to the battery 

negative (-) and insert the plug into e-power.

3.Turn the ignition switch to start position.

4.Once the car is started, disconnect the plug and remove the battery clips within *0s.