Feetech 15KG Serial Communications Robot Servo

详情

Feetech *5KG Serial Communications Robot Servo


SCServo can work at servo mode and wheel mode. 
The servo mode can be used to multi-joints robot since the robots can be controlled with specific angles. (The factory default setting is servo mode)
The wheel mode can be used to wheel-type operation robots since motors of the robots spin infinitely. (If wheel mode is available you need to program the value of position limitation the both are 0.)
If you want to reprogram servo, you need to download the PC software (SCServo_Debug), and to connect SCPC*2(Serial Control Programming Card) between servo and PC. 
More about SCServo_Debug and SCPC*2 introduce please reference its instructions.

SCServo has a unique ID number to identify on BUS network.
The range from 0 to **3 (0xFD) can be used (The factory default setting is ID 1), and, especially, **4(0xFE) is used as the Broadcast ID. If the Broadcast ID is used to transmit Instruction Packet, we can command to all SCServo.
After programmed servo ID, to be best way is written it on the sticker of servo. If not, maybe you will forget the ID when you programmed many servos.

SCServo have kinds of baud rate available.
The baud rate from ****0 bps to 1M bps can be used. 
They are ****0, ****0,****0,*****0,*****0,*****0,*****0,******0. (The factory default setting is ******0 bps)


SCServo can feedback the value of Position, Temperature, Load, Speed and Input Voltage.
Also we can reprogram the speed of rotation, the max output torque, operating voltage limit, and operating temperature limit etc.

SCServo is easy to be controlled by Arduino.