good quality led strip 5050

详情

1. good quality led strip ***0 2, IP*0 IP*5 IP*7 IP*8. 3. DC*2V/*4V; 7.2W/meter 4,CE & RoHS 5,High lumens good quality led strip ***0: 1. SMD***0, *0pcs LEDs/meter and *0 pcs LEDs/meter LED strip. 2. Power: 7.2W/meter, *4.4W/meter. 3. Color: White(***0K****0K), Red, Blue, Yellow, Green. 4. Waterproof: Non-waterproof(IP*0), Dripping adhesive waterproof(IP*5); Silicone tube waterproof(IP*6); Silicone tube and Glue waterproof(IP*8). 5. FPC: *0mm Width Yellow/White/Black FPC. 6. Input voltage: *2/*4V DC. 7. Length: 5 meter/roll. Application: Car Decoration Architectural decorative lighting Stairway Accent lighting Archway,canopy and bridge edge decoration. Assembly Information - Solder connection should only be performed on designated solder pads (marked � +/-�). During? soldering, don�t exceed the maximum soldering time of *0 seconds and the maximum soldering temperature of **0 Celsius degrees. - The smallest unit (*0mm or **0mm - 3 /6LEDs) can be removed by cutting with scissors between the designated solder pads. - The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partide. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned. Press on the strip with about *0N/cm2 (refer to application techniques of 3M adhesive transfer tapes). - The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.