Goods rack roll forming machine with punching

详情

d. Manual expanding core
e. No power transmit, with brake device

2. Straightening machine
a. Width of feeding: **0mm
b. Thickness of material: 2.5mm
c. Quantity of roller: *1 pcs
d. Thickness of roller: GCr*5 steel
e. Rigidity: HRC****7
f. Speed: 8m/min
g. Transmit: chain and wheel

3. Feeder
a. Width of material: **0mm
b. Thickness of material: 2.5mm
c. Quantity of roller: 4 pcs
d. Material of roller: GCr*5 steel
e. Rigidity of roller: HRC****7
f. Servo motor: 0.8KW (Mitsubishi)
g. Speed: ***0m/min
h. Transmit: wheel

4. *0T PUNCHING MACNINE
a. Nominal force: **0KN
b. Working times; *0 times/min
c. Equip punching mould:  3 sets (*0mm, **0mm, **0mm)                                             
each time punch **0mm, 3 rows hole

5. Roll forming main machine
a. Groups of roller: *0 nos
b. Material of roller : GCr*5 steel
c. Hot treatment of roller; HRC****7
d. Diameter of main shaft: *0mm, material: *5# steel
e. Bearing of roller: ****9
f. Thickness of side wall: *5mm
g. Transmit; chain and wheel
h. Motor; *5 KW, **0 speed reducer
i. Width can adjust by spacer
j. Equip cooling water pump device
k. Speed; **8 m/min

6. Cut-off
a. Oil pressure station: 1pcs
b. Motor: 3KW
c. Cut-off mould: 3 sets
d. Material of cut-off mould: Gr*2 steel
e. Rigidity: HRC****2

7. Run-out table
a. Length of table: 6m
b. Welded by angle steel
c. Pneumatic discharge material

8. Electric control part
a. Transducer; From Japan
b. PLC, Human machine interface, servo motor: Mitsubishi
c. Length is measured by cylinder
d. Control electric component: Tai Wan Shi Lin or Tian De, and Schneider
e. Stop machine cut-off