High degree of protection LED street lighting

Name

Specification

Quantity

Parameter

Solar panel

**0W/*2V

1 piece

• Polycrystalline, **6x**6mm,*6 piece.
• Size:***0x**0x*5 with *0cm wires,MC4 Connector. and Weight:*2KG
• Warranty: More than *0% output power in *0 years .and more than *0% output power in *5 years.
• The product have passed TUV, IEC, MCS etc certificate.

Light source

LED*0W/*2V

1 piece

• Single Integrated Power LED(*0W),Woking Voltage DC*2V,General luminous:***0lm,LED Luminous Efficiency:**0lm/W,Center illuminance:*4lx,Ra>*0,Color temperature:********0,Protection Grade :IP*5,Working life >****0, It can woke more than *0 years in accordance with *2 hours a day.
• Lamp shade is Die-casting molded with aluminum alloy,and its face is UV-resistant and corrosion resistant .
• No bad glare; No Strobe; Start without delay .Low maintenance cost .
• Production Size :**8x**0x**0mm ,Weight :6.*6KG

Controller

*0A

1 piece

• PHOCOS CIS Series,*2V/*4VAutomatic identification , light control and time control,Protection Grade IP*8

Battery

*2V/**0AH

1 piece

• Gel Battery that dedicated to solar energy. It can use recurrent more than **0 times in **0% discharge cases For the solar energy street lamp that in simple circulatory system. And its advantage is that :the small self -discharge rate ,the better deep discharge, Top charge acceptance, large capacity,strong start in low ,the good shock resistant and Anti-temperature charge Production
  • Size: **3x**0x**0mm,Weight :*4.5KG
    • Packing Size :**6x**3x**0mm,Weight :*6.4KG
      • The two Battery is used in series in this collocation

Pole and other steel fitting

6M

Set

• Best steel Q**5 or Q**5;hot dip galvanized and paint coated .
  • iron plate is rolled into type for one time .
    • Flange plate :**0x**0x*0mm
      • Solar panel bracket and 4# or 5# Angle iron,*0x5mm and **0x**0mm Flat iron. Square tube is assembled by bolt ,any section is made with mold. With high efficiency and precision , standardized parts can replace each other and the same time increase the packing quantity and reduce transport cost .
      • Battery body are welded after 2mm plate stamping molding

Wires harness

*-

1 piece

• With the special connector ,standardization,substitutability ,high installing efficiency,saving cost .
• Wire harness canbe designed according to different lamp type .

others

Baseplate *0 steel rod ,standard component and so on

Conditions

Voltage of system: *2V,working time: *0 hours ,Best work temperature **0degree**0degree

Packing Quantity

*0set/*0FCL