Specification for road
stud
1.Solar panel:2.5V/**0MA (monocrystalline)
2.Battery:1.2V/**0MAH (NI-MH battery,High
temperature resistant )
3.Working hours:>= **0h working in flash/
>=*2h working in steady after full
charging
4.Working model:flashing or steady
5.LED color:white,yellow,red,blue,green
6.LED:Ultra bright diameter 5mm,6PCS
7.Visual distance:＞**0m
8.Turn on Light Intensity:******0Lux
9.Life span:**5 years
*0.Work Temperature:**0℃～**0℃
*1.Matterl:Cast aluminum+reflectors+UV resistance
PC
*2.Size:**8***8**8MM,Net weight:**0g
*3.Waterproof:IP*8 ; Load capacity: >*0T
*4.Packing:*0**8.5**2CM,*0PCS/CTN
Product
Feature
1 solar power supply, energy saving and
environmental protection, convenient installation,
working mode automatically start lighting at
night
Two, installation method
1 installed on both sides of the road, pay
attention to whether spike solar panels can be
sunlight
2 installation useful glue and nail spike installed
by spike
Application
1. Dangerous blind corners and sharp-curves, black
spots and poorly lit areas.
2. Areas with unpredictable weather conditions
(coastal roads, foggy areas, wet and rainy regions,
etc.).
3. Joint intersections, on and off ramps, center
lines and dividers, entrance warnings, carpool
lanes, bridges, cross and side walks
4. Guidance lines, traffic islands, roundabouts and
mountain roads.oad
5. Taxiways at airports, bike and pedestrian lanes,
aboard ships and watercrafts.
Other
Information
1.*0 years solar charger & light
Manufacturer.
2.High Quality Control with CE, ROHS approval.
How to
install
1.Mix the glue first
2.Positioning :Road stud install place must to be
flat ,dry ,clean ,seamless
3.Stick with glue:using the proper quantity glue,
sticked on the ground firm, after installation,
please turn the road stud left and right once
again to ensure the road studs paste on the road
uniform
4.Road closures:Must be 6 hours of road closures
to ensure the glue curing time
