Water distiller MWD-1

详情

Important notes
Please read before use and file for future use before use
Unpack the water distiller and check all the components are present and undamaged. the box should contain:

1. distiller
2. water bottle
3. discharge cap
4. bottle cap
5. filter
6. main power wire
7. chamber cleaning powder
8. instruction manual

1. remove storage bottle from inside of water distiller
2. Fill tank inside of the machine’s body up to the highest water level line be very careful not to over fill tank. Time needed to distill water cab be reduced by using already boiled water.
3. Place top cover onto machine’s body making the silicone seal is currently in place around the entire rim. Check to make sure the unit is on a stable surface. Then connect power cord from the top cover into the machine’s body.
4. Set up storage bottle as per diagram. Connect power cord to power outlet.
5. Press ’starting ’. The fan will come on automatically and the tank will begin to heat. Thus starting the distilling process.
6. Water will begin to drip into the storage bottle after approximately *0 minutes. It will take approximately 4 hours to distill 4 liters of water. The unit will automatically shut down when the cycle has finished.

1. Do not use the first bottle of distilled water. It will take one distilling cycle for the unit to ’self-clean’. Wipe out tank and rinse/discard water in storage bottle. Distiller is now ready to create distilled water,

1. Pour in enough hot water to cover scale in the tank.
2. Pour **4 teaspoons into tank depending on the amount of scale.
3. Leave lid off unit and start up a cycle by pushing ’start ’.
4. Let cycle run for *0 minutes. Pour out water and wash the inside of tank with clean water.
5. If scale is not completely removed repeat the process.
6. Replace filter in lid every **3 months.