Z-Wave Dual Wall Switch

详情

The TKB Z-Wave dual wall switch is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol
It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.
Beside the local switch the unit can control other Z-Wave units remotely in up to three additional Z-Wave groups, which are associated with this device.

USE:

Tipping one time or two times the switching paddle performs the control.

The left paddle controls the local load while the right paddle remotely controls Z-Wave associated devices only.

The association of further Z-Wave devices needs to be done by a Z-Wave controller.

The unit is powered by **0V power and needs a pattress box with **0 V power wires for installation.

The unit is shipped completely with electronics, switching paddle and mounting frame in white style. It is designed for use within a *-wire system, which means that a neutral wire is needed for operations.

SPEC.

Power: **0 VAC, *0 Hz

Signal (Frequency): **8.*2 MHz

Maximum Load – Resistive: 6 amps (***0 watts) maximum, **0 VAC

Range: Up to *0 meters line of sight between the Wireless Controller and /or the closest               

 Z-Wave Receiver Module.