1.27mm Half-Pitch DIP switches

详情

DSHP Series     
1.*7mm  Half-Pitch DIP SW
 
Features:
Hyper-miniature DIP Switch,surfaced mount device base on 1.*7 mm pitch.
Lowest contact resistance less than *0m.
Twin points and gold-plated contact,reliable design.
All materials are UL *4VO grade,high temperature resistance plastic .
 
Packing:All DIP Switches Are Slipped In Standard IC Tubes Or Reel Package With All Poles In TheOFF.
 
Ratings:
Contact Rating
Switching         :*5mA at *4VDC
Non-Switching     :**0mA at *0VDC
 
Contact Resistance
Initial             : *0MΩMax
After life          :**0MΩMax
Insulation Resistance:**0MΩMin,*0sec at **0VDC
Dielectric Strength:**0VDC for *0 seconds
Switch Capacitance:5pF Max at 1 MHZ
Operation Temperature:**0℃~**5℃
Storage Temperature:**0℃~**5℃
 
Mechanical&Processing
Operation Force:***0gfMax
Mechanical Life :***0 cycles Operations
Resistance to Soldering:**0±5℃for **5 seconds
Electrical Life: ***0cycles *5mA *4VDC
 
Switch Operation and Taping
1. Use Tweezers or ball point pen for operation
2. Flux cleaning should be done without removing the tape
3.If the Tape is removed ,it adhered less than before when it Is placed back on,possibly causing  flux inflow.
4. Sealed switches withstand aqueous,detergent and isopropyl alcohol washing .
 
Environmental TEST
Cold Resistance Test
Switches under temperature at - *0℃ ±2℃for *6 hours
 
Dry Heat Resistance Test
Switches under temperature at *5℃ ±2℃for *6 hours.
Humidity Test
Per MIL-STD- **2F,Method **3B Test Condition B:
There shall be no evidence of corrosion and the insulation resistance shall be no less than **0   megaohms
 
Vibration Test：
Per MI-STD- **2F,Method**4 D，Test Condition A：
There shall be no opening of closed contacts or closing of open contacts in excess of *0  microseconds.
 
Shock Test:
Per MIL-STD- **2F,Method **3B ,Test Condition A:
There shall be no opening of closed contacts or closing of open contacts in excess of *0 microsecond.
 
Thermal Shock Test:
Per MIL-STD- **2F,Method **7G，Test Condition A:
There shall be no evidence of physical damage or permanent change in electrical characteristics .
 
Salt-Spray Test
Per MIL -STD - **2 F,Method **1D,Test Condition B :
There are under *5℃ ±2℃  in temperature and 5±1% salt-water concentration for *8±1   hour.