1.Chips
could be copied
***0(all
manufacturers);***2(All manufacturers);PT***4, ***6(All
manufacturers);SC***2, HT**0, HT**0, HT***7, HT***0, HT***2,
HT***4, SMC**8series,**7(All manufacturers);***7(All
manufacturers);***0(All manufacturers);HCS**1, HCS**0HCS**1(part
code),HCS**0HCS**1(a part of the code), part single chip
microcomputer..........
2.Code
cleaning method:
Press
the unlock and lock at the same time(some shells
are the up and down ), after the LED indicator light
flashes three times, loosen any one of the s while the
other is kept pressing, then push the released three
times, the LED indicator will enter into the fast flashing
status. At this time all the memory data is cleared, the cleaned
remote control will not have lighting LED indicator no matter
which you press.
3. Copy
method
One hand
keeps the original remote controller, while another keeps the
copy remote control, the two remote controls should be placed as
closely as possible (the ideal situation is to put the two remote
controls on the desktop side by side with zero distance),
respectively press down the copy , when the LED indicator
light flashes quickly after three flashes, this copy is
successful, other key operating methods are the same. Some remote
control has a smaller transmitting power, so the original remote
control should be placed back to the copy remote control to be
operated. For the presence of noise, it should avoid interference
to operate, If the copy is not successful, it should recopy after
clearing code.
The
features of new copy remote control:
The four
s could respectively copy four different types of chips,
That is a remote control can operate four different types of
facilities. The frequency is from **0MHz to **4MHZ and more than
ten frequency points. Faster copy data speed, not easy losing
code, far distance.