Injection Molded Plastic Parts

详情

Injection molded plastic parts knob switch is an important device of microwave oven, based on the electrical life of the micro switch, and the actual operation, the user is usually in the microwave oven power off the case of the open and close the microwave oven, this is only related to the mechanical life of micro switch, so the real failure rate of the microwave oven is much lower. The microwave oven cavity is made of stainless steel. There are three parallel shallow grooves on the left and right walls. Each pair of parallel shallow grooves can be inserted into the plates equipped with this microwave oven. Two stainless steel irons, each with two magnets attached, are mounted on the left external side of the chamber.

Microwave oven work usually adopts the combined method, namely, microwave and barbecue is take turns to work, this is mainly consider the microwave power at work usually above 1 X (X) W, and barbecue when electricity is usually in 1 X (X) W above, by using a more complex combined timer, by in a microwave oven on the wheel motor drive CAM control by microwave oven on the control of the control panel to control, with different functions, the output power is different, to combine various CAM control at the number of micro switch and panel knob controls the number of micro switch, is its flexibility.

Injection molded plastic parts knob switch is made of PC+ABS material, which has good comprehensive performance, high impact strength, chemical stability and good electrical performance. High impact resistance, high heat resistance, flame retardant, enhancement, transparency and other levels. Easy to injection and extrusion, blow molding; Good electroplating; Good surface brightness, easy injection and extrusion. The bottom is circular, the part held by the hand is rectangular, the upper and lower ends are smooth and bright, no scratches means the mold design is very good demoulding; Easy to install and operate.