OriSun QYKEL**0 cable is designed as motor lead extension cable
applied for electruc submersible pumping units to link the power
from motor to the main power cable. The motor lead extension
cable, also referred to as teh motor flst, is a sepcially
constructed, low -profile, flat cable. It is spliced to the lower
end of the round or flat main power cable, banded to the side of
the ESP pump and seal chamber section. Male termination (pothead)
needs to be applied at the end of this cable for plugging or
splicing into the motor electrical connection. Because of its
need for low profile, it requires compact construction. It
generally has a thin layer of high-dielectric-strength polyamide
material wrapped or bounded directly to the copper conductor.
This allows for a thnner layer of insulation material, allowing
for a lower profile. The MLE is generally selected on the basis
of equipment: casing clearance and teh voltage capacity
requirement.
OriSun QYKEL**0 is rated for service from **0F (**0C) to **0F
(**2C), which is a premium cable for wells with higher tempreture
requirements. Motor lead cables have three layers of polyimide
half-lapped and heat sealed film directly over the conductor.
This polyimide film has a very high dielectric integrity. Monel,
stainless steel or galvanized steel armor provides an overall
protection for these cables. Cable protectors are recommended to
be used for highly deviated wells or wells with a minmal
clearance.
