Sell bitumen flow meter for Jacket Insulation

详情

The flow meters are applicable to the following ranges: Diameter , Φ*5Φ***0mm or bigger. High and low temperature, ***6***0. High pressure : **2Mpa. Characteristics Measurement flow of liquid, gas, steam, ropy mediums or ambulatory mediums in low, normal or high temperature condition. Total quantity measurement accuracy is not less than 0.2%. High sensitivity, able to measure very low velocity below 0.8m/s. No movable part, safe and reliable. Wide measure range, bigger than 1:*0. Good repeatability, generally 0.*0.*8% , fast to measure. Small pressure loss, only about 1/2P of Standard Hole Board. Able to adopt hang weight method to test the flow meter. Measurement range can be changed by replacing target according to need. LCD display. Description a. Connection flange shall execute relevant technical requirements in state standard GB/T***5.1~***5.*****0. b. All standard flanges from other countries (Japanese standard, USA standard and German standard etc.) are special order. c. For high temperature type and temperature/pressure compensation type, in addition to pipeline flange, connection mode can be clamped mounting type, inserted type or threaded structure. d. Jacket insulation type (heat conducting type) is suitable for applications in which preheating and thermal insulation, or process thermal insulation are required to eliminate media solidifying and crystallization during process flow. This type is normally used for viscous media such as modified asphalt and coal tar etc. e. When media temperature in high temperature type flowmeter is >**0, upside-down horizontal installation must be used for the instrument. For the purpose of design, sufficient installation space shall be considered. f. In case media flow up-down or down-up, for ordering, please note: right view, left view (showing gauge head) Size Nominal inside diameter Total width Total height Conventional product