Sell Asphalt Mixing Plant LBJ 800

详情

Characteristics of LBJ**0 asphalt mixing plant This equipment adopts the modularized design so it is easy to install and dismantle. There is no over-limit size of each system, so it can be conveyed by container. I. Characteristics of the cool aggregate batching system 1. The belt stuff-supplier is controlled by electromagnetism with wide governor deflection, well-smooth and high efficiency. ***** is a vibrator on the wall of gravel hopper to avoid the phenomenon of blockage caused by arch unity. ***** the top of of each hopper there is a interlayer to prevent the entry of bigger aggregate., therefore guarantees the reliability of the system II. Characteristics of the cool aggregate conveying system 1.A vibration screen is setted at the entry of the feeding conveyer to prevent the stone with large diameter entering the drying cylinder, this largely decrease the volume of scrap. ***** is not only saved energy, promoted the heat efficiency but also guarantees the reliability of the drying cylinder, hoister and vibrating sieve, therefore lengthen its life-span. III. Characteristics of drying cylinder 1. The drying system is the key component of the whole set, the capacity directly influences the productivitythe temperature of the dried aggregate directly influences the temperature of the finished productits efficiency directly influences the consumption of the fuel, thereby the rational structure is very important. We fully absorbed the domestic and abroad advanced technology of stirrersuch as Japan technology, Korea Newlife, English Pike and got satisfactory results and realized the anticipated object. 2. The structure of drying cylinder is columnar, its slant angle is about 4°.It is fixed in a lower trestle set to have a lower barycenter to ensuring its smoothly running. 3. The drying cylinder is droved by friction wheels with four electric motor drive synchronously, so it can run smoothly and quietly. Compared with the former one which was droved by big gear wheel and chain, it is quieter and with smaller shock pressure. 4. The rational structure of the windlass blade in the drying cylinder promoted the heat efficiency of the drying cylinder, the windlass blade and the body are fixed by screws, thereby settled the problem of difficult replacement after abrasion. At the same time avoid the phenomenon of out-of shape and fall-off caused by wielding. 5. The mineral cotton layer added in the outside decreased the loss of heat, thus decreased the consumption of the fuelnotethe oil consumption of our company is 6~7kg/t, the standard is 7kg/tand increased the drying productivityThe wrapper in the outside use stainless steel, so it is sightly to look. 6. The discharging manner is scraper sideway discharge from the bottom, the port is low, so the output is even and smooth.