详情
Typical
application
Screened oversized
particles
wood
chips
waste
veneer
barks
trimmings of wood
based panel
board
straws
stalk
bagasse
reed
cotton stalk,
etc.
Characteristic of the
machine
1.Three rotors hammer
flakerhas
very new and compact design concept, there are three rotors
installed inside the machine and rotate relatively. Twin-rotor
hammer rotate with a high speed to grinding the material, central
rotor knives cut the crushed material to proper size. Flakes size
can be controlled by different shapes of the screen meshes.
Assorted high wear resistant hammers and counter grinding shoes
interplay with each other, grinding and cutting the material into
qualified flakes. The energy consumption can be lowered over *0%
comparing with traditional hammer
mill.
2.high-quality tailor-made wear-resisting screen
mesh can be chosen according to the shape of the flakes, Particle
size can be adjusted by changing different screen
meshes.
2 .Due
to raw material has very complicated shapes and varies quality,
insufficient centrifugal force of the knife ring flaker is hard to
achieve effective cutting. Therefore, the performance is lowered.
However,three
rotors hammer flaker
hasa
unique structure, it has strong adaptability and low requirements
towards quality and shape of the material, and has wide range of
application
.
3.Normally the spare parts only include hammers,
screen meshes, rotor knives, etc. They are very easy and few
minutes to replace spare
parts.
4.Thethree
rotors hammer flake works very
stable.
It has characteristic of low operating cost,
energy saving mode, high capacity and good shape of the
flakes.
5. Motor spindle drives directly and motors
rotate stably and quickly with positive and negative
direction.
6.Self-lubricate SKF bearings can increase
flaker’s
lifetime.
7. The
hammer and the rotor knives are made of special metal which had
been gone through thermal treatment as well as been welded high
wear resistant material. In this way, they are sharp with long
lifetime. As a result, whole machine’s cutting force is improved
and the energy consumption is
lowered.
8.high-quality tailor-made wear-resisting screen
mesh can be chosen according to the shape of the flakes, Particle
size can be adjusted by changing different screen
meshes.
9.The machine is
easy to be maintained. Its doors can be opened from both sides
Hammers and screen meshes can be changed rapidly. There is
induction type security lock installed
inside.
