Coil winding Nozzle(Tungsten carbide wire guide nozzles)used
in coil winding machines to guide the wire to wind in the bobbin,
pins and etc. For the manufacture of coils, motors, transformers,
relays, inductance and sensors in automotive, telecoms, electric
and electronic applications.
Features:
1. High Wear Resistance
This is assured by the choice of materials for wear elements
possessing a minimum hardness in excess of Vickers 1, **0 (HRC
*0).
2. Scratch-Proofing
Eliminate wire insulation film damage, low friction resistance,
stable wire tension. The wire-guiding surfaces are mirror finished
by diamond lapping to a surface roughness of 2 *4 micro inches Ra
or better, material permit.
3. Straightness and Stiffness
Straightness and Stiffness are defined by the wire exit being
concentric and inflexible with respect to the nozzle locating? . In
plain terms, the wire should exit from the nozzle concentric to the
locating? To within 0.*2 mm, with or without load. A geometric
characteristic presentation is shown at upper left. Concentricity
to within 0.*1mm.
4. Precise Exit Radii
Because the coil winding nozzle' s Exit Radii governs the angle of
the wire exit from one coil to the next, it should be monitored to
+ / - 0.**5 mm. This is done by digital measurement, shown at upper
right.
Specification:
Measurements:
Customize available by requested, outside diameter is governed by
nozzle wall thickness. See the measurements drawing to confirm your
nozzles measurements according to your winding machine and coil
products.
