Sell Electric Bike Battery 24V, 10Ah, Lithium battery

详情

Product Specification/Models

1. Rated Capacity: *0Ah: Standard discharge (2A) after standard charge
2. Minimal Rated Capacity: 9Ah: Standard discharge (2A) after standard charge
3. Nominal Voltage: *4V: Mean Operation Voltage
4. Cycle Life: Higher than *0% of the Initial Capacities of the Cells, Carry out **0cycle
Standard discharge (2A) after standard charge
Discharge: 2Ah to *1V
Rest Time between charge/discharge: *0min.
Temperature: *0+/*5 Degrees Celsius
5. Voltage at end of Discharge: *1V, Discharge Cut-off Voltage
6. Charging Voltage: *9.4V
7. Standard charge: 2A CC(constant current)charge to *9.4V, then CV(constant voltage *9.4V) charge till charge current decline to ≤0.*1C:Charge time : Approx 6h
8. Standard discharge: Constant current 2A end voltage *1V:
9. Maximum Continuous Charge Current: 1C(*0A):
*0. Maximum Continuous Discharge Current: 2C(*0A):
*1. Operation Temperature Range: Charge: 0~*5 Degrees Celsius, *0+/**5%R.H.
Bare Cell Discharge: **0~*0 Degrees Celsius
*2. Storage Temperature Range: Less than 1 year : **0~*5 Degrees Celsius, *0+/**5%R.H.
at the shipment state: Less than 3 months: **0~*0 Degrees Celsius;
*3. Weight: Approx: 2.8Kg:
*4. Pack Dimension: High: **2mm Width: *7mm Long: *6mm

3. Performance And Test Conditions
3.1 Standard Test Conditions
Test should be conducted with new batteries within one week after shipment from our factory and the cells shall not be cycled more than five times before the test. Unless otherwise specified, test and measurement shall be done under temperature of *0±5 Degrees Celsius and relative humidity of *5~*5%. If it is judged that the test results are not affected by such conditions, the tests may be conducted at temperature *5~*0 Degrees Celsius and humidity *5~*5%RH.
3.2 Measuring Instrument or Apparatus
3.2.1 Dimension Measuring Instrument
The dimension measurement shall be implemented by instruments with equal or more precision scale of 0.*1mm.
3.2.2 Voltmeter
Standard class specified in the national standard or more sensitive class having inner impedance more than *0k&branded;/V
3.2.3 Ammeter
Standard class specified in the national standard or more sensitive class. Total external resistance including ammeter and wire is less than 0.*1&branded;.
3.2.4 Impedance Meter
Impedance shall be measured by a sinusoidal alternating current method (1kHz LCR meter).
3.3 Standard ChargeDischarge
3.3.1 Standard Charge: 2A
Charging shall consist of charging at a 2A constant current rate until the cell reaches *9.4V. The cell shall then be charged at constant voltage of *2 volts while tapering the charge current. Charging shall be terminated when the charging current has tapered to 0.*1 C5A. Charge time: Approx 4.5h, The cell shall demonstrate no permanent degradation when charged between 0 and *5 Degrees Celsius.
3.3.2 Standard Discharge: 2A
Cells shall be discharged at a constant current of 2A to *@********************5C
3.3.3 If no otherwise specified, the rest time between Chare and Discharge amount to *0min.
 

Application
Electric Bicycle,e-bike, e-bicycle, bike