Sell Diagnostic tool for FORD

FoCOMdiagnostics software allows you to perform complete diagnostics of all ****-present Ford models. Diagnostics is performed via OBD-II connector (which is located near steering wheel).
Supported functions
Unlike other universal Ford car scanner tools which only read fault codes, this software performs nearly ALL the functions like the original dealer diagnostic tool. Our Ford diagnostic interface contains K-Line multiplexor, CAN-BUS interfaces and SAE J***0 bus (both PWM and VPW).
The following diagnostic functions are supported:
1. Read identificationDisplays complete identification of control unit, e.g. part number, software/hardware version, manufacturer, etc...
2. Read fault codesDisplays all stored and pending fault codes with complete description (e.g. "Rail pressure - too low pressure").Program supports report printing or copy to clipboard.
3. Clear fault codesThis function clears all stored fault codes and other diagnostic information.
4. Auto-scan (complete car scan/test)Detects all Ford ECUs (electronic control units) installed in car and reads all diagnostic fault codes.
5.Measured ValuesProgram displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in graph, 9 values at once, or full listing (all measured values). Logging to file is also supported, which allows offline analysis.
6. Actuator testActuator test activates particular actuator (e.g. turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off fuel, etc..)
7. Programming functions/AdaptationThis feature is of great importance in all vehicles because systems like Engine control units, Immobilizers, Airbags, Alarms, Body Control Units, and some others, require you to perform reset or programming procedures after car repair is done, or even configuration after replacing broken Control Unit.

Supported language:

1.English2.Germany3.Czech 4.Hungary:Hungary - Magyar

5.Croatian (hrvatski jezik)6.Netherlands7.turkey

Hardware and software requirements
Software requires at least Intel Celeron/Pentium III **0 MHz, **8 MB RAM, *0MB free HDD space and USB 1.1 port (USB 2.0 recommended) and Microsoft Windows *8 SR2/***0/XP with the latest service pack installed.