离岸价格
获取最新报价60 ~ 100 / Set
|Minimum Order
位置:
Guangdong, China (Mainland)
最小订单价格:
最小订单:
10 Set
包装细节:
soft/hard/netural/aluminum case, etc
交货时间:
next day for sample dispatch and whthin 3 days for
供应能力:
30000 Set per Month
付款方式:
T/T, L/C, Western Union, PayPal
联系人 Cherry-candicemo
Address:No.1 Yinlandong Rd,Xiejiazhuang,Taihe Town,Baiyun Distric, Guangzhou, Guangdong
First: Open the trunk
Second: Remove the negative cable from the battery using the *0mm wrench. To get at it you have to remove the panel on the drivers side that holds the first aid kit. Most US cars do not have the kit so it’s just empty inside. You will see a cutout in the trunk liner, give it a tug and you will have access to the rear of the taillight.
Remove ONLY the connector with the 4 large wires. You remove the connector by pulling back on the green tab and pulling the connector out. Some pliers used gently helps on this. You can see the upper *0mm nut in this photo. After removing the upper and lower *0mm nuts you can now pull out the taillight. You will have a hole in your car like this. To install the new light simpily insert it into the hole and snug down the *0mm nuts. DO NOT OVERTIGHTEN. They only need to be snug. Do not re-install the wiring harness. Do the same to remove and install the passenger side. You will be looking at something like this. To remove the harness squeeze on the tabs on each side of the connector and pull it out.
KEY WORDS:hid ballast,hid light,hid projector light
