Sell 6051 pi film/Tape/Sheet/Tube

详情

Polyimide FEP(F*6) film (similar to Kapton FN) is made of coating Polyimide film with FEP resin(F*6) on one side(FH) or double sides(FHF) and through the sintering process at high temperature, which combines the excellent properties of Polyimide film and FEP resin of high& low temp resistant, radiation resistant, corrosion resistant, excellent electrical properties, superior dimensional stability and heat sealable properties. It performs successfully in the wide range of temperature as low as ***2F(**0c) and as high as ***0F(***0c). Polyimide FEP(F*6) film (similar to Kapton FN) widely used for insulation in motor, electrical apparatus and wrapping of cable and magnet wire, heater manufacture etc.

Characters:

* Higher mechanical strength, better dielectric strength with thinner insulation ply;

* Excellent heat resistance ,used as class- H insulation and can work for a long term at

**0°C but short time at **0°C;

* Good flexibility, better tear resistance and excellent workability, and can be glued on the

different-sized workpieces;

* Self-sticking and good bonding strength , no removal after stripping off;

* Different thickness and width to meet customers’ specific requirements;

Application

Electrical and Electronics, circuit board manufactureH grade electric engine, transformer coil and capacitor insulation wrapping up in high-temperature, high-voltage conditionSMT thermal resistance, golden finger protection of PCB boardHigh temperature resistance and waterproof for electronic transformer

Specification

1. Other construction is available upon request; FEP layer thickness: 0.*1mm +/**0%

2. Width: *0 ~ **0mm; Core ID:*6mm; Roll OD:**0~**0mm

3. Min Qty: *0kgs each size in a lot.

Our Factory Competitive Advantages

About factory:

Jiangsu Yabao Insualtion Material Co., Ltd. was established in ***6,

specializing in producing insulation materials: i.e. 

Packing

The tape roll and disc should be rolled up on a pipe core whose internal diameter is about *6mm, and then the tape roll and disc should be packed into a plastic bag with good sealing, and then be transported into a wooden box with damp-proof paper or into a dry and clean carton.