详情
The SSMΙΙΙ is a powerful fault diagnosis device (for Subaru
vehicles) that has been developed using the latest advanced
technology. Used in combination with a PC, it provides a tool for
quick and efficient analysis of vehicle faults.
Application software running on a PC provides an interactive user
interface for very simple operation. High-speed communication with
the engine control system and transmission control system help to
make checking of various phenomena faster than ever before.
The SSMΙΙΙ is a fault diagnosis device that provides a standard
means of automotive fault diagnosis. It communicates with the
various system control modules equipped in a vehicle to monitor
control module input/output data, and to allow checking and
deletion of diagnostic codes generated by the controlmodule. It
also provides means to reset control module learning values and
other control parameters, and to force operation of engine control
system actuators.
Features:
All System Diagnosis. Selecting this item displays on a single
screen the fault detect status of all control system control
modules for which SSMΙΙΙ diagnosis is supported, and memorized
diagnostic codes.
Each System Check. Selecting this item makes it possible to select
a particular system from among the control systems forwhich SSMΙΙΙ
diagnosis is supported, and perform fault diagnosis. This item can
be used to view input/output data of the system control modules
that perform fault diagnosis, memorized diagnostic codes, and other
data on the PC display.
This menu item is also used after repair work is complete to delete
diagnostic codes, to configure control module settings, etc.
Saved Data Display. This item can be used to save various data
sampled during fault diagnosis operations, and to load data for
viewing after work is complete. Immobilizer. This item performs
immobilizer registration.
Reprogram. This item performs reprogramming of the control
module.
Read CF application measurement data. This item performs reading
stand alone measurement
data saved in a CF card to hard disk of your PC.
Convert/Save measurement data on driving recorder. Loads data
sampled on the driving recorder to the PC from the CF card, and
converts and saves that data.
Oscilloscope. After attaching the optional pulse/analog cartridge
to SDI, connect the pulse/analog box to the SDI and using
pulse/analog probe to perform analog sampling.
Minimum Computer Operating Requirements:
Operating System: Microsoft Windows ***0/XP
CPU: Intel Pentium M processor; **0 MHz equivalent or higher
recommended
RAM: **6 MB recommended
Available Hard Drive Capacity: *0 GB recommended
Drive: CD-ROM drive
Communications Port: USB port (USB 1.1 or higher)
Homepage: obdiishop.net
