Sell

Electronic Rust Stop Device

Protect Your Automobile Body From Rust & Corrosion.

Auto Rust Control module is pumping the electrons at your vehicles body.

These electrons make up a barrier in between atmosphere & steel structure of the car.

Installation:

Specifications:

Input Voltage: *2 Volt DC.

Ground: (-) Negative.

Current Draw: 0.3 mAmp

Impressed current 2Hz Frequency speed of electrons pumping.

 Anode Composition:

"Auto Rust Control" non-sacrificial.

Command Module Size:

Anode: *0mm X *0 mm.

Weight: **0g.

The Auto Rust Control module attaches to your regular car battery and draws about as much current as your cars clock. Over every 8 second cycle it emits a surge of "free" electrons throughout your vehicle to the very places your car has lost its protective paint and coatings (through stone chips, scratches, and abrasions) and "shields" these exposed areas from harm. The charge is too small to be noticed; however the free electrons interfere with the rusting process and retard rust and corrosion significantly.

Auto Rust Warrior is one of a kind and substantially extends auto body life through Electrolyte capacitive discharge oxidation interference (ECDOI), a form of impressed current technology.

The Auto Rust Warrior ® Rust Control module.

      1 Built-in conductive pad

      1 Gray wire for body

      1 Over voltage safety Fuse.

      1 Black ve Battery wire

      1 Read +ve Battery wire

      1 Installation instruction

      1 Packing bag along need full connectors and screws.

Connect the +ve ARW wire to +ve Battery terminal.

1. Connect the -ve ARW wire to -ve Battery terminal.

1. Connect the Gray Wire to car body.

1. Auto Rust Warrior Light will be glowing.

1. Select the suitable place for Auto Rust Warrior module.

1. Clean the surface with cloth

1. Remove the back side sticker cover from module & paste it on vehicle body.

         The installation is completed !!!