chemical and Changchun road crossing, Zhengzhou, Henan
现在联系
详情
The main working part of hammer crusher is rotors with hammer. The
rotors consist of main shaft, disk, pin shaft and hammers. The
motor drives the rotors to rotate quickly in the crushing cavity.
Raw materials enter the crusher through the feed opening and are
stricken, impacted, cut and ground by the high-speed hammer to
small size.
There is a screening plate under the rotor, so that m?aterials with
size smaller than the screen mesh will be screened out and others
are left to be further hammered and ground until reach the standard
size. The size of the final product can be adjusted by changing the
screening plate. The gap between the rotors and the screening plate
can also be adjusted according to different requirement.
