Sell lipo laser machine

详情

Work Principle:

The Laser-lipolysis emits low levels of laser energy, which creates a chemical signal in the fat cells, breaking down the stored triglycerides into free fatty acids and glycerol and releasing them though channels in the cell membranes.  The fatty acids and glycerol are then transported around the body to the tissues that will use them during metabolism to create energy. This process of fatty acid release is a natural response of the body when the body needs to used stored energy reserves, thus Laser lipolysis is not creating any unnatural reaction in the body nor does it affect or damage any surrounding structures such as skin, blood vessels and peripheral nerves.  A period of exercise post treatment will ensure the complete metabolism and thus elimination from the body of the freed fatty acids.

Application:

* Intensive physical lipolysis to remove fat
* Excess fat cell melted
* Body slimming, cellulite reduction
* Smooth Fatigue
* Remove obstruction from channels and collaterals
* Promote the body's metabolism

Theory:

Laser for fat reduction,use the **0nm soft laser to destroy the deep fat cells,broke the cell membrane,change the fat to triglyceride,then leave out the body to metabolism.

The laser heat can Stimulate the subcutaneous dermal tissue collagen and elastic fibers hyperplasia,make the treated area skin tighten and elasticity .

Laser Function:

1.Operation step of Laser 2X 
(1)Clean the skin, and according the treatment part to choose the suit band ties and tied them up.
(2)Put the Laser 2X work heads into the band ties, the side with Led contact to skin directly. 
(3)Set intensity of every Laser 2X in interface (Fig 3) shows.  the range is 1(weak)~3(strong).

Operation steps: 
  When the cursor "V" on the location "channel 1 1Hz", click"←" and "→"to set the intensity of laser, the 
range is 1HZ~***0HZ. OFF means that close channel 1.

 Then move the cursor “V” to the “channel 2 1HZ”, click"←" and "→"to set the intensity of laser, the range is 1HZ~***0HZ. OFF means that close channel 2.etc.

(4)Setting work time 
     Click “Time” to enter interface (Fig 4). click"←" and "→"one time to change one minute, click the number of time directly to change ten minutes every time.*0 minutes of every treatment part.

(5)click "="to start work.

(6)The machine will pause automatically if the setting time is over. Beautician take the Laser 2X work head 
out and put them well, then loosen the band ties.

2.Operation step of Laser 4X 
(1)Click the “Laser 4X” in interface (Fig 3) shows to enter interface (Fig 5).
(2)The other steps please refer to “Laser 2X Function”.