Operation Guidance of Jump Starter: When charging, the
indicator lights will flach one by one. The number of solid
indicator lights indicates the battery capacity of Jump Starter.
Full indicator lights are solid when charging is pause or complete.
1, Select the appropriate voltage and connector for
the electronic device to charge / power supply
2, Press the switch to start charging; If you unplug the cable,
auto-sleep will start in one minute.
3, Five lights will flash circularly during the charging and all
lights will keep bright when your device is full-charged
4, During the charging for your device, LED lights indicate the
balance power of built-in battery. Four lights indicate *0%
balance, three lights indicate *0% balance, two lights indicate *0%
balance and one light indicates *0% balance. The built-in battery
is empty whenall LED lights start to flash
5, Press the switch 3 seconds to start If you want to use LED
illumination and then 4 modes of LED light appear in sequence(
light, strobe, SOS, close) by pressing the switch to
transform.
6, Store the product in a cool and dry place and away direct
sunlight. Special
note:
To start *2V car, please make sure at least two LED lights are
bright firstly, then connect the red battery clip to the battery
positive (+) and black clip to the battery negative (-) and insert
the plug into the jump start socket, finally turn the ignition
switch to the START position. Once the car is started, please
disconnect the plug and remove the battery clips immediately(within
*0 seconds).
