Remote Control IR Repeater/ IR Extender with 1
Receiver & 1 Emitter ( for 1 AV Device ) & USB 5V
adaptor U***-P
Remote Control IR Repeater can be used with weak
IR Remote control signal from players such as IPTV. CD/VCD/DVD/
Blu-ray, Home System, Television, Setup box, recorder, CATV,
Karaoke system, etc. It is also recommended for Players/ Equipments
which are concealed in console or cabinet.
Operating at *4KHz ~ *0KHz, This IR Repeater/ IR Extender is
the smallest yet powerful IR repeater/ IR Extender with high speed
transmission without delay.
Series available as follows
: U
Series powered by USB 5V and D series powered by DC*2V
U**1, U**1A, D**1 **- 1 Receiver 1 Emitter ( for 1 AV Equipments
)
U**2, U**2A, D**2 ***1 Receiver 2 Emitters ( for 2 AV Equipments
)
U**4, U**4A, D**4 ***1 Receiver 4 Emitters ( for 4 AV Equipments
)
U***-P. U**1A-P, U***-P, U**2A-P, U***-P, U***-AP etc. – USB 5V
Adaptor Included
U**1, U**1A, U**2, U**2A, U**4, U**4A etc. – USB Power Adaptor not
included
PACKAGES:
1. USB Adaptor 5V **0mA
Our U series which is powered by USB adaptor ( Included ) can also
be powered by connecting the USB cable to the USB port on your AV
Equipment.
2. IR Receiving Head is distributing :
(1). USB ( use to connect to USB 5V adaptor or AV devices for power
) Length : 2m
(2). IR Emitter ( Emitter to be stuck on the IR Point of your AV
equipment ) length : 3m
INSTALLATION :
1.
Clean the surface of your AV equipment. Stick the IR Emitter on the
IR point of your AV Equipment
2. Place the IR Receiver such a way that it is facing your remote
control. It is advisable to place away from Plasma or CCFL screen
as it may affect the remote control signal.
3. Connect the USB to USB Adaptor/ USB port of AV Equipment for
power
4. Power up & all is ready to go.
TECHNICAL SPECIFICATION
:
Receiving Frequency ( Broadband ) : *4KHz ~
*0KHz
Emitting Frequency ( Broadband ) : *8 KHz & *6KHz
Receiving Distance : 8 meter
Emitting Distance : ****0 cm
Power Consumption : < *0mA
Dimension for Receiver & Emitter : *1 (L) ×*7 (W) ×*3 (H) mm,
*3 (L) ×8 (W) ×5. 5 (H) mm
Input AC ******0V/ Output DC 5V : USB 5V
**0mA
FREQUENTLY ASKED QUESTIONS
: 1.
How to locate the IR Point of the AV Equipment?
A. Set up as per the installation procedures without step one. With
the help of an assistant controlling the AV equipment Remote
Control, move the IR Emitter around on the window of AV
equipment until signal sent is received.
2. Remote Control doesn't work after installation ?
A. Check the power status of your AV equipment
B. Check the connection of USB to AV Equipment/ Power adaptor
C. Ensure that remote control is facing the IR receiver ( Flashes
red when a signal is sent )
D. Check the position of IR Emitter.
E. Place IR Receiver away from Plasma or CCFL screen as it may
affect the remote control signal.
F. Contact your dealer if the situation does not improve after the
above alteration.
