详情
dental polishing lathe
dental polishing lathe for lab ZB-PMJ
This polishing machine is widely used to cutting and polishing all
kinds of metals in prosthetic
dentistry,eg:nichrome,cobalt-chromium alloy,stainless steel
material,flexible denture,bridges and porcelain teeth.
Main technical parameter:
Voltage :**0v
Frequency :*0hz
Power :**0w
Package size:**0***0***0mm
Rotage speed:***0 rotate/minute
Clamp :spiral type
Caution.
1. Please operate it with the voltage and frequency stipulated on
the rating label of the machine.
2. Before operate the machine, the crust should connect the
earth.
3. Please operate the machine far away from the gas that
flammability and easy to explode.
4. Prohibit knocking down the safety guard to operate.
5. Do not operate it outside.
6. Please operate it far away from drenched world.
7. Please do not let the children close to the operating
machine.
8. The rotating direction of the machine should be same to
indicator drop.
9. The operator should wear goggles or dustproof glass.
*0. When operate the machine, please do not let the workpiece clash
into grinding wheel , to avoid the grinding wheel break
up and hurt people.
*1. When finish operation and power off suddenly, you should turn
the switch to the close position, to avoid to startup
suddenly and hurt people.
The operation of the machine
1. The machine can be used on the place of altitude not exceed ***0
minutes, environmental temperature between *5°C****5°C
and surrounding comparatively humidity ≤*5%.
2. Before use the machine, please check every accessory carefully,
if damaged during transportation or the fastener is not
hard up or not. If yes, it should be repaired and
fastened.
3. Before use the machine, should turn the axis of rotation by
hand, it should be agility without scuffing. If have
scuffing,
should find out the reason and eliminate it, only after that, the
machine can be used.
4. The machine equipped with 2pcs polymethyl methacrylate plastics
safety-guard glasses, connect with the bracket of the
glasses, then mounted it on the grinding wheel shield shell. You
can adjust the point of view according to the requirement
to
achieve the dustproof function.(for polish machine III)
5. The pedestal of the machine have fixing hole, when necessary it
can be fixed with a bolt to use.
