Electroplating Hard chrome aseptic technic inside the mold, which
do not rust easily with long service ages.
In the structure of the gypsum block mold, the Ra value of the
surface roughness on the joint side is not less that
3.2.
Sealed structure with no slurry leaked, without any hard friction
to operating surface, which makes the service ages more
longer.
The Ra value of the surface roughness between forming mold and the
operating face of the evacuated tubes, materials should be less
than 1.6. we have made it between 0.6 - 0.8, which has exceeded the
national standard.
Advantage
Less investment: 4 pieces in 1 set, simple operation and high
production speed, one worker can produce **0 pieces of boards per
day .
Good product
Boards are in good flatness, without plastering, the walls
reached the high-level standard of covering of
stucco.
Low cost: The main material is the desulfurization gypsum
powder.
***5 cm of thickness is available in wall panels producing, using
these wall panels will effectively expand the housing area of
6%.
The features of light weight, heat insulation, soundproof and
fireproof meets the national policy of energy-saving and
consumption reduction.
Unique structure: two boards recessed docking, fast installation
and improve the strength of high-impact of the wall
panels.
3. Substantial Profit
Production Procedure
Transferring proper proportion of raw materials to stirring
machine.
Pouring the materials mixed in balance into the
mold.
Pulling → Stripping → Drying → Loading
