Sell EXTERIOR FLAT FINISH

详情

PRODUCT DATA

• Remanufactured

• Low Odor

• Environmentally Preferred

• Excellent Quality

• Exterior Flat

• Excellent Adhesion

• Easy Application

• Soap & Water Clean-Up

DRYING                                       

• To Touch *0 - *0 minutes

• To Re-coat 4 - 6 hours

• Times may vary depending

on environmental conditions,

Temperatures & humidity

PHYSICAL PROPERTIES

• Finish: FLAT

• **6% *@********************• Approximately *5% Volume Solids

• Package Viscosity ******0 KU

• Approximately ******0 sq. ft. per gal

• 1.5 to 1.7 Mils DFT

APPLICATION METHODS

Product may be applied with brush, roller or airless sprayer.

Maintain a \'wet edge" and apply coating uniformly. Do not Apply if material, air or surfaces Temperature is below *0° F

Surfaces and ambient temperatures must be between *8° F and **0° F 5° above dew point and remain above *8° F

a minimum of four hours after application. Test all products for compatibility prior to application

THINNING & CLEAN UP

Product is supplied without the need for thinning MAXIMUM ½ pint per gallon added if thinning is required. Clean up with warm, soapy water.

COLORS

Available in assorted stock colors.

Custom colors and specialty products are available.

V O C

MAXIMUM VOC

SURFACE & APPLICATION

WOOD:Clean, dry & dulled surface optimal. Remove all loose & flaking paint. Remove loose Unstable wood fiber. Prime all new wood with appropriate primer.

METAL: Clean, dry & dulled surface optimal. Primeall new metal with appropriate primer.

Surfaces to be rust free, and clean from

all forms of contaminates.

MASONRY: Clean, dry & dulled surface optimal.

Allow ****0 days for all new masonry

to cure and to provide proper pH

before priming & painting.

CAUTION: