Sell plastic pipe fitting injection mould

详情

Detailed Product Description

Quick Detail:

1. The part name: pipe fitting (plastic injection mold)

2. Plastic material: PA*6+GF*0

3. Cavity material: H*3 HRC****2

4. Mold life: ***0k shots or according to customers quantity condition to decide it with saving cost for our customers.

5. Gate type: Sub-gate, direct gate, fan gate, point gate, edge gate, valve gate, tip gate etc according to our customers requires.

6. Mold base standard: LKM Local standard, DME or HASCO,Customize according to customers\' requirements

7. Standard of mold accessories: LKM, DME, HASCO, MISUMI, Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS, MOLD-MASTER, MERKLE, Parker, HPS, LKM, EUCHNER, RJG, cilpres, NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO JIS standard, PUNCH etc according to our customers requires.

Description:

The part name: pipe fitting

Mold type: Plastic Injection Mould

Part Material: PA*6+GF*0

Locating ring Dimension: Ф**0

KO Pattern: **0***0

Sprue Radius: SR *9

Gates/Runners: sub gate cold Runner

Ejection type: ejection pins

Mold construction description: cold runner system with sub gate, slider, 2 plates, and a lot of shut off area.

This product is made of PA*6+GF*0 plastic material and it is one of the components of the reputable brand pipe fitting. The construction is complicated and there are hydraulic cylinder, hydraulic motors, gear, fan gear, gear-rack in the mold, also have Internal and external thread in the product, so it has a very high technical requirement for the mould design. The mould is a cold runner mould with water cooling system and the part can be molded by both automatically and manually.

This part has very high appearance and size requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport,Sliver Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under dimension,Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE-B3.

This mould is made in Shiny Mould Factory. It is a mould exported to Europe, with complicated structures and high quality requests. Customer needs mold life to be over 1 million shots. We can ensure this mold life and give warrant to our customer that once some mould components are broken during working, if it is caused not by the operation fault from the workers, we can provide new mould components to them free of charge.