Remote Differential pressure / pressure transmitter is used to
prevent the pipeline in the medium directly into the transmitter
pressure sensor component, it is between the transmitter fill fluid
by capillary connected. Used to measure liquid, gas or steam level,
flow and pressure, and then into 4 ~ *0mA DC signal
output。 JG***1/***1DP/GPPressure/Bring
the remote seal pressure transmitter, you become a
JG***1/***1DP/GPRemote
pressure/Pressure
transmitter, it still has a JG***1/***1DP/GPPressure/Various
characteristics of the pressure transmitter. WithHARTThe
terminal communicate with each other through it to set,
monitor。
Avoiding the measured medium and the transmitter isolation
diaphragm direct contact, this measurement method is suitable for
the following several cases: 1、The
measured medium on the transmitter-sensitive components have
corrosion 2、Need
to isolate the transmitter measured medium heat 3、Measured
medium in suspended solids or high viscosity media 4、Measured
medium pressure pipe from the lead or lead crystal at the same time
easy to cure 5、Replacement
of the media should be strictly tested probe
purification 6、Measuring
head must be kept sanitary, non-pollution. Use Object: corrosive or
viscous liquid
Note: The vacuum should not be used where remote
transmitter。 JG***1/***1DP/GPRemote
pressure/Pressure
transmitter four types of remote devices:
1、***1PFWFlat
remote device (standard3″、Work
stress2.5MPa) 2、***1RTWScrew-mount
type remote device (maximum working pressure*0MPa) 3、***1RFWFlange
mounted remote device 4、***1EFWType
of remote device into the drum (standard3″Or4″,Work
stress2.5MPa)