Bolt-on type for most cars
and trucks, no need welding (if the car steel plate is too thin
then need welding.) Just need to drill for fixing
bolts.
· Four heavy duty Gas
Struts
·
Adjustable Stop Points
· CAD Designed
· Maintains
factory safety, accessories & function
· They are universal and can be fitted to any
vehicle
Features:
CAD
Designed
Adjustable Stop Points
Maintains factory safety, accessories & function
4 Heavy duty Gas Struts
Detailed Instructions
3.
Installation:
16. Extend all wiring running into the door, to allow for
vertical travel, (solder all connections to prevent electrical
problems) open and raise to measure for wire length. Remove wires
from the loom and cut. Cut on wire at a time to prevent mistakes.
Solder the appropriate extension lead and tape/heatshrink. Repeat
with all wires. A longer wire loom may be needed.
17. Make all the proper adjustments, to allow for smooth opening
and closing operation. See Fine Tuning section below.
18. With door open, attach strut to the hinge, locate and mark
mounting position for ball stud on chassis.
19. Attach ball stud to chassis using either the supplied mount or
fabricate one for your specific application.
20. Re-attach fender and all parts, that were removed and test
motion.
