详情
Manufacturer sell 1.*5mm/3mm ABS PLA HIPS Nylon
3D printing filament
Specifications:
Material: PLA ABS
Colours: more than *0 colors
Filament diameter: 3mm or 1.*5mm
Inner diameter: *6mm
Packing: 1kg/ spool/ vacuum pack (with desiccant) /box
PLA filament characteristics:
(1)No block nozzle, good stick hot bed, a smooth PLA used
(2)can be processed at **5 degrees
(3)low shrinkage, thermoforming dimensional stability
(4)Good toughness high strength, high stiffness
(5)No-toxic, odor harmless, good smell
ABS is commonly used in 3D printing, has the following
characteristics:
(1) high strength, good toughness;
(2) density is small, when printing larger volume model lighter,
save money;
(3) cost-effective, can be processed in wide range temperature;
(4) softer than PLA;
(5) diameter of 3.0/1.*5mm, variations + /*0.*3mm,roundness
+/*0.*3mm;
(6) 1 kg /plastic spool packaging, can be automatic feed;
(7) to be applied to a variety of 3D printer, Makerbot, Mendel,
Prusa, Huxley, BFB series, etc..
Our ABS filament advantages compare to other ABS PLA
filament:
We select of premier grade ABS PLA material, low water
absorption, high tough. Factory direct sales, inexpensive, buy
more, bigger discount! !
Production Control:
1.Produce process
I . Before produce extruding filament ,we will dry ABS and PLA for
a enough time (**5 hours).
II. Mix with colors masterbatch or colors powder, all which
.certified with ROHS.
III.Adjust temperature and dragging rate , make filament diameter
range at 1.**1.8mm/2.**3.0mm, roundness +/*0.*5mm, each spool net
weight 1kg+/*0.*5kg
IV we put all filament spool in shelf, different kind in different
shelf, all categories arrange orderly.
2.Productiong quality control
I. we have diameter laser detect kits to
control extruding rate on line, when diameter smaller or higher
than accept range, the laser detect kits will adjust the extruding
rate higher or smaller to make diameter range at acceptable.
II.keep each record filament samples
sent to customers, build a tracking able document.
III.when the filament put on shelf
longer than half a year, we will dry the filament again.
3.About waste & recycle
Much time you will find some black filament is too brittle, that
added and mixed with some recycle and scrap after produced.
We haven’t produced with scrap outlet, rework&recycle material,
or dispose, but for quality assurance purpose.
4.Packaging
We put each filament /spool on seal PE
bag with desiccant , then smaller carton, then out big box
We also have vacuum heated bag to
replace of PE bag, make better avoid moisture.
5.Research and developing
we have engineers that specialty in
color formulation ,plastic modification, packaging, quality control
,producing control, we can do according to your requirements .
