GPRS RTU telemetry Data Logger alarm and controller

详情

>>>>>>>GPRS Data Logger S**0 Features:

> Direct connection to the GSM GPRS Network;

> Transparent Serial Data Tunneling using low cost SMS/GPRS network;

> Remote Configuration by SMS Messages or GPRS;

> Upload data via GPRS or SMS on Schedule or event occurs;

> Supports Dynamic Domain name or fixed IP address;

> Supports SMS, CSD, GPRS, UDP and TCP/IP protocols;

> Supports Modbus RTU protocols;

> 2 RS**2 Serial Ports, and 1 RS**5 Serial Ports;

> UP TO 6 OPT Coupler (***4V) Digital Inputs can be programmed to NC/NO/Edge/Level type by switch, OPT and NON OPT can be programmed by switch, when alarm occurs can send Alarm Messages by SMS or GPRS or auto dial the preset phone numbers;

> UP TO 6 digital inputs can be used as Pulse Counters;

> UP TO 4 OPT Digital Outputs can be programmed as dial to switch on/off with free communication fee, alarm-linkage and Schedule to action, also can be send SMS to switch on/off;

> UP TO *0 Analogue Inputs. (*2 bit resolution, **5V or ***0mA can be programmer by switches);

>UP TO 4 Digital Relay Outputs :**0VAC/3A, *4VDC /3A, Can be controlled by Event, scheme, Incoming call, SMS Commands, Timer, Interlock; 2 outputs can setup as NC or NO type;

> User friendly PC Programming Interface, it can remotely program the terminals as well as to  upload the data from the terminals by SMS or GPRS, all of the Current Value or status of the terminal can be display directly, and also will display the SMS Command details while you programming it;

>>Quad-band  MC*5i GPRS Module and High-density Performance Line ARM **-bit MCU Inside
>>Direct Connection to the GSM GPRS Network
>>Transparent Serial Data Tunneling using Low Cost SMS/GPRS Network
>>Remote Configuration by SMS Messages or GPRS
>>Upload Data via GPRS or SMS on Schedule or Event Occurs
>>Support Dynamic Domain Name or Static IP address
>>Support SMS, GPRS UDP and TCP Protocol
>>Support Modbus RTU Protocol
>>USB/RS**2/RS**5 Serial Port
>>6 Opto-isolated Digital Inputs can be Programmed to NC/NO/Edge/Level Type by Switch
>>Passive Contact Type and Active Contact (3~*4VDC) Type can be Programmed by DIP switch
>>DIN1 and DIN2 are Completely Isolated
>>When Alarm Occurs can Send Alarming Messages or Auto Dial the Preset Phone Numbers
>>6 digital inputs can be used as Pulse Counters;
>>4 Digital Relay Outputs can be Programmed as Dial to Switch ON/OFF with Free Communication Fee Alarm-linkage and Schedule to Action,also can be Send SMS to Switch ON/OFF
>>*0 Analog Inputs(*2 bit Resolution, **5V or ***0mA)
>>2 Thermometer Inputs for DS*8B*0, Measures Temperatures From **5°C to ***5°C. (Fahrenheit equivalent is **7°F to ***7°F)±0.5°C 
>>4 Power Source Outputs for External Device
>>Support 1 SMS Center Number and 1 IP address or 1 Dynamic Domain name
>>MTBF(Mean Time Between Failure) up to 2Years
>>User Friendly PC Programming Interface
>>Power supply 9V to *4V(Recommend *2VDC).