1. Ash Content, not more
%........................................................................0.*4 2. Mass fraction of sulphur, not more % low -
sulphur - residual - oil ……...……….0.5 3.
Temperature of the flash, not less
°C in the closed crucible °C ……….*5 min in the open crucible °C
……………………**0 min 4. The temperature of solidification, not higher
°C …………………………*5 5. Kinematics viscosity ………………………………………..**8
max 6.
Water content %
………………………………………… …0.5 7. Mechanical impurities Lower than %
…………………… 0.1 8. Acidity Lower than 5 mg KOH/
……………………………**0ml 9. Alkalinity…………………………
………………………….nil *0. Gross Calorific Value Kcal/kg / KJ/kg Min
…………… .***0/****0 *1. Density at *5.0 °C
Kg/……………………………
0.**00-0.***0 *2. Hydrogen Sulfide Content (H2S) pom
…………………0.5 max *3. Carbon Residual Lower than % …………………… …
.7 *4. Vanadium (V) ppm
……………………………………….*3 *5. Aluminium (Al) ppm
………………………………………5 *6. Silikon (Si) ppm
…………………………………………..*2 *7. Nickel (Ni) ppm …………………………………
………*9 *8. Asphaltenes m/m % …………………………
…………3.6 *9. Destilation at 4 mm Hg Extracted to **0 mm Hg Initial Boiling Point °C
………………………………………………………………..**6 5% recovered °C
……………………………………………………………………..**9 *0% recovered °C
……………………………………………………………………**0 *0% recovered °C
……………………………………………………………………**8 *0% recovered °C
……………………………………………………………………**5 *0% recovered °C
……………………………………………………………………**2 *0% recovered °C
……………………………………………………………………**4 *0% recovered °C
……………………………………………………………………**8 *5% recovered °C
……………………………………………………………………**5 *0% recovered °C - *0% recovered °C - Final Boiling point °C
…………………………………………………………….......**0 Percent Recovered vol %
……………………………………………………………*8 Residue vol
%.....................................................................................................*2 Total Nitrogen m/m %
………………………………………………………………..0.**2 *0.
Sodium (Na) ppm
………………………………………………………………..*5
